Fix Leaking Bathtub Drain Stopper: Expert Tips
Is your bathtub drain stopper dripping or leaking water? It's not only an annoyance, but it can also lead to water damage over time. Fortunately, fixing a leaking bathtub drain stopper is a task you can tackle on your own. Let's dive into a step-by-step guide on how to repair this common plumbing issue.
Before we begin, ensure you have the necessary tools. You'll need a flashlight, needle-nose pliers, a flathead screwdriver, and a new stopper if required.
Identifying the Issue
Before you start, identify the type of drain stopper you have. There are two common types: pop-up and non-pop-up. The method to fix them differs, so it's essential to know which one you're dealing with.
For pop-up stoppers, you'll see a lever or a knob on the overflow plate. When you lift or push this, the stopper will rise or lower in the drain. Non-pop-up stoppers, on the other hand, don't have this lever and are constantly in the drain opening.
Inspecting the Stopper
Begin by inspecting the stopper in the drain. If it's a pop-up, lift the lever to raise the stopper. If it's leaking, the issue might be with the stopper itself. If it's not leaking when raised, the problem could be the pop-up rod or the lever assembly.
If the stopper is cracked or damaged, you might need to replace it. Home improvement stores carry bathtub drain stoppers that are easy to install.
Evaluating the Drain Assembly
If the stopper isn't the culprit, inspect the drain assembly. The pop-up rod and lever assembly often wear out over time, causing leaks. The overflow plate, where the drain meets the tub wall, might also be damaged or improperly installed, leading to leaks.
To check the pop-up rod and lever assembly, lift the overflow cover plate to expose the mechanism. If it's difficult to lift or doesn't function smoothly, it might be the cause of the leak.
Repairing the Drain Stopper
Now that you've identified the issue, let's proceed with the repair.
Replacing the Stopper
If the stopper is damaged, it's time to replace it. Start by removing the overflow cover plate. Then, use a flathead screwdriver to pry the old stopper from the drain opening.
After removing the old stopper, clean the drain opening to ensure a proper fit for the new one. Install the new stopper by placing it into the drain opening and securing it with a setscrew located on the underside of the drain.
Tightening the Set Screw
If the stopper isn't damaged but leaks when it's down, the setscrew that holds it in place might be loose. Tightening the setscrew can often fix the issue. To do this, use a flathead screwdriver to turn the setscrew clockwise until it's tight.
If tightening the setscrew doesn't solve the problem, the pop-up rod or lever assembly might be worn out. In this case, you'll need to replace these components.
Replacing the Pop-up Rod or Lever Assembly
Replacing the pop-up rod or lever assembly involves removing the old components and installing new ones. Start by disconnecting the rod from the drain knife by turning the cam lever counterclockwise. Then, use needle-nose pliers to-unscrew the rod from the assembly.
Once the rod is removed, discard the old assembly and replace it with a new one. Reassemble the parts in reverse order, ensuring everything is secure and functional.
After your repair, test the drain stopper to ensure it's no longer leaking. If water no longer drips from the drain when you run water in the tub, your repair was successful!
Regularly maintaining your bathtub can prevent leaks from happening in the future. Keep an eye on your drain stopper, and ensure it's functioning properly to avoid water damage. If you're ever unsure about a repair, don't hesitate to contact a professional plumber. Regular maintenance and prompt repairs will keep your bathroom in top condition.