Fix Overwound Clock: Easy Step-by-Step Guide
If your clock is running fast and you've determined that it's an over-wound or over матче clock issue, don't fret. Adjusting an over-wound clock is relatively simple and can be done with just a few tools and some patience. Let's dive into a step-by-step guide to fix your over-wound clock.
Before we proceed, it's essential to understand how your clock works. Most mechanical clocks use a mainspring to power the clock's movement. When wound too tightly, this spring can cause the clock to run too fast. Thus, to fix an over-wound clock, we need to reduce the tension on the mainspring.
Understanding Your Over-Wound Clock
Not all clocks are created equal, and the method to fix them might vary. However, the principles remain the same; we need to reduce the tension on the mainspring.
Here, we'll discuss the two most common types of clocks: pendulum clocks and grandfather clocks. If you own a different type of clock, the general principle will still apply, but you might need to adjust the steps slightly to accommodate your specific clock's design.
Pendulum Clocks
Pendulum clocks are probably the most common type of mechanical clock. They typically have a single hand that moves slower than a minute hand, known as a second hand. To fix an over-wound pendulum clock, we'll first need to access the clock's movement.
To do this, carefully remove the clock's face and any protective covers to expose the clock's inner workings. Once you can see the clock's movement, you should notice a small hook or lever directly connected to the pendulum. This is the pendulum's crutch, and it controls the pendulum's swing length, thereby adjusting the clock's speed.
Grandfather Clocks
Grandfather clocks, also known as longcase clocks, are tall, freestanding clocks that typically have a pendulum visible through a glass door. Thanks to their design, adjusting these clocks is straightforward.
To fix an over-wound grandfather clock, start by opening the clock's glass door. You should see the clock's pendulum swinging back and forth. Look for any adjustable screws or knobs on the clock's face or side. These are used to adjust the clock's speed. If your clock doesn't have these, it might have a screwed weight support that adjusts the clock's speed when turned.
Adjusting Your Over-Wound Clock
Now that we've located the adjustment points on your clock, let's proceed to slow it down.
Remember, you can always add more time to your clock, but you can't take time from it. So, it's best to make small adjustments and check your clock's accuracy regularly until you find the perfect setting.
Pendulum Clocks
For pendulum clocks, use a flathead screwdriver or a small knob to gently bend the pendulum crutch downwards. This will slightly increase the swing length of the pendulum, making your clock run slower. Be careful not to bend the crutch too far, as this could damage the clock's movement.
After adjusting the crutch, allow the clock to run for about an hour. Then, check the time to ensure your adjustment was successful. If the clock is still running fast, repeat the process. If it's not running fast enough, gently bend the crutch back up to decrease the swing length and speed up the clock.
Grandfather Clocks
For grandfather clocks, turn the adjustment screws or knob counterclockwise. This will slow down the clock's movement. Again, only make small adjustments and allow the clock to run for at least an hour before checking its accuracy.
If your clock has a screwed weight support, turn the screw clockwise to slow down the clock. Remember, only turn the screw a quarter turn at a time to avoid over-adjusting your clock.
Congratulations, you've just successfully fixed your over-wound clock! Regularly check your clock's accuracy and re-adjust as needed. Now that you know how to fix an over-wound clock, you can keep your timepiece running smoothly for years to come.