how to fix a manual can opener

How to Repair a Manual Can Opener: Step-by-Step Guide

By Steven Lopez
AD

A manual can opener is an essential kitchen tool that can break or wear out over time. Thankfully, fixing a manual can opener doesn't require you to be a professional mechanic. Follow these straightforward steps to renew your can opener and enjoy consistent, safe, and efficient can opening for years to come.

Before you start, gather your tools. You'll typically need a Phillips or flathead screwdriver, a set of Allen wrenches (if the screws aren't standard), pliers, some lubricant (like WD-40 or grease), and your can opener itself.

Inspecting and Lubricating the Can Opener

The first and easiest step in fixing a manual can opener is to inspect it for signs of wear and tear, then lubricate the moving parts.

AD
someone is using a lighter to put something in a cup
someone is using a lighter to put something in a cup
How To Clean a Can Opener
How To Clean a Can Opener
How to Fix Can Opener? 🍲🔍
How to Fix Can Opener? 🍲🔍

Check the gears, the cutting wheel, and the handles. Look for excessive wear, damage, or tight spots that might hinder smooth operation.

Cleaning the Can Opener

Start by cleaning the can opener with warm, soapy water. Use a soft-bristled brush or cloth to remove any debris or rust from the gears and Moving parts.

How Long Should A Can Opener Last?
How Long Should A Can Opener Last?
How to Sharpen a Can Opener Blade
How to Sharpen a Can Opener Blade

Rinse with clean water and dry thoroughly with a towel to prevent any leftover moisture from causing rust later on.

Lubricating the Can Opener

Apply a small amount of lubricant to a clean cloth or paper towel. Wipe the gears, the pivot point of the cutting wheel, and the points where the handles meet.

AD

Be careful not to over-lubricate. Excess lubricant can attract dirt and grit, which will counteract your efforts.

Replacing Broken or Worn Parts

Sometimes, a can opener needs more than just a good clean and lubri-cation. Here's how to replace the most common parts that break or wear out.

Replacing the Cutting Wheel

The cutting wheel is the component that actually cuts through the can. If it's blunt or bent, it's time for a replacement.

AD

To remove it, use pliers to gently pull out the retaining pin. Replace the wheel, then tap or press the new retaining pin into place.

Replacing the Handle Spring

The spring that connects the two handles can break or stretch out over time. To replace it, use a screwdriver to remove the screws that hold it in place.

Replace the spring, ensuring it's properly seated and functioning. Tighten the screws gently to avoid stripping them.

AD

After fixing your manual can opener, test it on a can of food that you intended to throw away anyway. If it works well, you're ready to go. If not, double-check that everything is secure, lubricated, and functioning correctly. With proper care, your fixed can opener should serve you well for years to come.

AD