how to fix a dry highlighter

Revive Your Highlighter: How to Fix a Dry Highlighter

By Sarah Moore
AD

Finding your highlighter hasn't quite highlighted enough lately? Or perhaps it's as dry as the parched month of July. Fret not! You can revamp your highlighter and restore its gleaming glory. Let's explore some essential tips on how to fix a dry highlighter, making your studying, reading, or marking tasks enjoyable again.

Before diving into DIY solutions, ensure your highlighter is intended for correction or highlighting purposes. Techniques may differ due to its composition and intended use. This article mainly focuses on the widely-used felt-tip highlighters, not correcting pens or markers.

Understanding the Highlighter Ink

The magical ingredient in your highlighter - the ink - is generally a water-based dye. When it runs out, it's often due to drying up, not necessarily being used up. So, let's explore how to restore moisture and get your highlighter back in business.

AD
How to Fix a Dry Highlighter | ehow.com
How to Fix a Dry Highlighter | ehow.com
How to Fix A Dried Out Highlighter | Effective Solutions (2026)
How to Fix A Dried Out Highlighter | Effective Solutions (2026)
How to Fix a Dry Highlighter Pen Work Again | 4 Helpful Methods
How to Fix a Dry Highlighter Pen Work Again | 4 Helpful Methods

Before attempting any fixes, ensure your highlighter is unused, not making it worse. Also, note that these methods will work best on mild dryness; severely dried-up highlighters might become unsalvageable.

Moistening with Water

A simple and effective solution is to add moisture back to your highlighter using good old H2O. Here's how:

a woman is holding a blue pen in her hand
a woman is holding a blue pen in her hand
Highlighter hacks
Highlighter hacks

1. Find a bowl or glass of lukewarm water. Ensure the water isn't too hot, as extreme heat can damage the highlighter's felt tip.

2. Immerse the highlighter's tip into the water, taking care not to submerge the ink reservoir area to avoid water damage.

AD

3. Allow it to soak for five to ten minutes, then remove it and let the excess water drip onto a towel.

4. Test the highlighter on a scrap paper or notebook to see if its consistency has improved. If not, repeat the process, adjusting the soaking time as needed.

Using Rubbing Alcohol

For a more potent solution, you can use rubbing alcohol, which is harsher but more effective than water:

AD

1. Pour a small amount of rubbing alcohol into a shallow dish or onto a cloth.

2. Dip the highlighter's tip into the rubbing alcohol or roll it gently on the cloth, ensuring the ink doesn't get picked up.

3. Let it sit for a few minutes, then remove it and test on a scrap paper. The highlighter should function better with the alcohol's help.

AD

Reviving a Completely Dry or Old Highlighter

If your highlighter has been sitting idle for a long time, resulting in a completely dried-out tip, you'll need a more aggressive approach:

Rewetting and Reconditioning

This technique is more involved but could save your forgotten highlighter:

1. Soak the tip in warm water or rubbing alcohol as described earlier.

2. Use a pin or a needle to poke a small hole at the bottom of the highlighter barrel, near the tip.

3. Squeeze a few drops of ink from a new highlighter or mix some food coloring with water to create your own ink. Gently drip the ink into the hole until it starts seeping through the tip.

4. Cap the highlighter and gently roll it between your palms to distribute the ink evenly.

5. Repeat the soaking process and reconditioning as necessary until the tip yields a consistent line again.

After attempting these methods, test your highlighter on paper to check its improved performance. Store it correctly after use to prevent future dryness and enjoy its newfound vibrancy. Happy highlighting!

AD