How to Drain LG Direct Drive Washer
Ever found your LG direct drive washer acting up, with signs of water remaining in the drum or tub after a cycle? This could be due to a drainage issue, and addressing this promptly can prevent damage to your appliance and your clothes. Here's a step-by-step guide on how to drain your LG direct drive washer and resolve common drainage problems.
Before you commence, ensure the washer is unplugged from the power source for safety, and gather your tools: a flashlight, adjustable pliers, a crescent wrench, and a block of wood to protect the washer's outer finish. Now, let's dive into the process.
Locating the Drain Hose and Clogs
The first step involves inspecting the drain hose, a vital component of your washer's drainage system. Typically, you'll find it at the rear bottom of the appliance, connected to the pump intake housing.
However, before you begin, ensure that the drain hose is not kinked, which could prevent water from flowing freely. If it is, straighten it out and check if the washer drains normally. If not, continue to the next step.
Clearing Minor Clogs
Sometimes, clogs can occur within the drain hose due to lint and other debris. To clear these, you'll need to disconnect the hose, rinse it with water, and then reconnect it.
To do this, use a pair of adjustable pliers to loosen the clamp securing the hose to the pump intake housing. Gently pull the hose free, supported by a block of wood to prevent stress on the washer's outer finish. Once free, rinse the hose with fresh water, clear any debris, and then reattach it.
Dealing with Persistent Clogs
If clearing the drain hose doesn't solve the problem, the clog could be located within the drain pump itself. To access this, you'll need to remove the back panel of the washer.
First, disconnect and remove the drain pump hose from the pump. Use a crescent wrench to loosen and remove the drain pump from the washer. Then, with the pump removed, inspect the intake screen for any clogs or debris. Clean the screen and reinstall the pump.
Checking the Drain System Beyond the Washer
Sometimes, the issue isn't with the washer itself but with the drain system it's connected to. It's crucial to ensure that the standpipe, the 2-inch diameter pipe that the drain hose empties into, is correctly installed.
Use a flashlight to verify that the standpipe extends at least 30 inches above the standing water level in your drain network. If it doesn't, the issue might be with the standpipe, which could need replacement.
Inspecting the Standpipe
The standpipe can become clogged over time, especially if not maintained properly. To check if this is the case, use a flashlight to inspect the top of the standpipe for signs of clogging. If you find any debris, try to clear it using a bent wire or a pipe cleaner.
If the clog is stubborn or located deeper within the standpipe, you may need to disassemble and clean the standpipe in its entirety. Ensure that all components are correctly reassembled and that the standpipe is securely attached to the drain hose.
There you have it – a comprehensive guide to draining and maintaining your LG direct drive washer. Regular checks and maintenance can extend the life of your washer and ensure optimal performance. If you're unsure about any of these steps, don't hesitate to contact a professional. Happy washing!