Mastering the Bob: Stepping-by-Step Guide to Cut Short Layered Bob Haircuts
Transforming your hairstyle can have a tremendous impact on your overall appearance. If you're considering a short layered bob, you're in luck. This classic yet trendy cut is not only chic but also easy to maintain. Here's a step-by-step guide on how to achieve this perfect look at home, along with some tips and tricks to keep your layered bob looking its best.
Before you start, ensure you have all the required tools and products. You'll need sharp haircutting scissors, a rat-tail comb, hair thinning scissors, hair clips, a comb, a styling brush, hair smoothing balm, and your preferred haircutting method - either a hair cutting cape or an old T-shirt to protect your clothing.
Preparation
The key to a successful haircut is preparation. Start by washing and detangling your hair. Towel-dry it gently to remove excess moisture, then apply a heat protectant spray to prevent damage. Comb your hair straight with a comb, then part it as desired. A center part works well with a bob but feel free to experiment with different parts.
Dry your hair slightly with a blow dryer on low heat. You want your hair damp, not soaking wet, for easier cutting and styling.
Determine Your Length
Before you start cutting, decide on the length of your bob. A layered bob can be Anything from chin-length to just above the shoulders. To determine the length, comb your hair straight down, then measure from the bottom of your earlobe to where you want the ends to fall. Mark this point with a clip or a small piece of tape.
Use this as a guide to trim the longest layer. Remember, layered cuts are all about creating depth and texture, so your final length may vary slightly from one section to another.
Start Cutting
Begin cutting at the longest layer, above the mark you made earlier. Section off a small portion of hair at the front of your head, near your face. Work in small sections, clipping back the hair you're not currently working on.
With your rat-tail comb, section off a small, even section of hair. Hold it taut with your fingers, then use your sharp scissors to make a smooth cut straight across, slightly below your marked length. Be careful not to hold your hair too tightly to avoid pulling or tension.
Layering Your Bob
Layering is what gives a bob cut its texture and shape. Start by sectioning the hair at the back of your head, just below the occipital bone, and clip it away.
Take a small section from the bottom layer of hair and cut it several inches shorter than the initial length. This will create the base layer. Continue cutting the hair in small sections, gradually decreasing the length as you work your way up the back of your head.
Layering the Sides
Moving on to the sides of your head, repeat the layering process. For each section, use your rat-tail comb to measure and cut at an angle, following the shape of your head. This will help create a rounded, inverted bob shape.
As you reach the middle of your head, be mindful of the transition between the back and side layers. To blend these layers, take a section from the back, then add a small section from the side. Cut this combined section to create a blended length.
Layering the Front
The front layers are cut last to frame your face. Start by sectioning off the hair near your face, clipping away the rest of your hair. Divide this section into several smaller sections, then decide the desired length of your bangs. Remember, shorter bangs can be styled in more ways.
Using your rat-tail comb, measure and cut your bangs straight across. For a more blended look, point-cut the ends of your bangs with your hair thinning scissors. This will create a soft, graduated effect.
Once you've finished cutting, style and trim as needed. Remember, it's easier to take off more hair than it is to add it back. Don't be discouraged if your final cut isn't exactly what you envisioned. With regular trims and styling, your layered bob will grow on you.