-how-to-clean-whirlpool-washer-drain-pump-step-by-step
Ever noticed a puddle of water around your Whirlpool washer? Chances are, your washer's drain pump could be the culprit. Not to worry, though! With a little DIY spirit and some simple tools, you can tackle the problem and restore your washing machine to its spotless, hassle-free self. Let's dive into the step-by-step guide on how to clean your Whirlpool washer drain pump.
Before you begin, ensure your washer is unplugged and you've turned off the water supply and power sources. Safety first! Now, let's explore how to clean and fix your Whirlpool washer drain pump, boosting its efficiency and prolonging its life.
Inspecting and Accessing the Drain Pump
The drain pump in your Whirlpool washer is typically located at the bottom front of the machine. Here's how to access it:
1. First, empty the washer's pedestal (if applicable) by removing the screws at the top corners and lifting the cover.
2. Once you've exposed the drain pump, locate the pump housing. It's usually a large, square-shaped plastic component with two hoses connected to it - the drain hose and the standpipe hose.
Draining and Disconnecting the Hoses
Before proceeding, you need to drain the hoses connected to the pump housing. Here's how:
1. Place a large bucket or container underneath the drain hose to collect any residual water.
2. Carefully remove the clip or clamp securing the drain hose to the pump housing, then disconnect the hose. Allow any water remaining in the hose to drain into your bucket.
Removing the Pump Housing
With the hoses disconnected, you can now remove the pump housing:
1. Check for any visible screws or bolts holding the pump housing in place. Remove them carefully.
2. If there are no visible fasteners, the pump housing might be snapped onto place. You can gently pry it off using a flathead screwdriver or a small, flat tool. Be cautious not to damage the housing or the washer's interior.
Cleaning and Inspecting the Drain Pump
With the pump housing removed, you can now access the drain pump. Let's clean and inspect it:
1. Using a small brush or an old toothbrush, gently scrub the impeller (the rotating part of the pump) and the inside of the pump housing. This will help remove any accumulated lint, hair, or debris.
2. Check the impeller's bearings for any signs of wear or wobbling. If the bearings are damaged or the impeller is too wobbly, it might be time to replace the entire pump.
Clearing the Drain Hose
While you're at it, don't forget to clean the drain hose as well. Here's how:
1. Reach up into the area where the drain hose was connected to the pump housing and feel around for any blockages or kinks.
2. If you find any, gently work them out using your fingers or a long, thin tool. Once clear, reattach the drain hose to the pump housing and secure it with the clip or clamp.
Inspecting the Standpipe and Drain
Before putting everything back together, it's a good idea to check the standpipe and drain for any issues:
1. Ensure the standpipe is securely attached to the back of the washer and that the flexible hose connected to it isn't kinked or damaged.
2. If your washer is plumbed directly into your home's drainage system, check that the drain line isn't clogged or damaged. You can do this by running a snake or a plumber's auger through the line to clear any obstructions.
With all components clean and inspected, you can now reassemble your Whirlpool washer. Reattach the drain pump and its housing, reconnect the hoses, and replace the pedestal cover. Don't forget to plug your washer back in and restore the water and power supplies.
There you have it! By following these easy and practical steps, you've successfully cleaned and maintained your Whirlpool washer's drain pump. Regular upkeep will ensure your washer continues to run smoothly and efficiently, saving you time, money, and unnecessary stress. Happy cleaning!