how to check transmission fluid chevy cruze

How to Check Transmission Fluid in Chevy Cruze

By Michael Lewis
AD

Checking your vehicle's transmission fluid is a crucial part of routine maintenance. For Chevy Cruze owners, understanding this procedure can help you identify potential issues early, ensuring the longevity and smooth operation of your car. Let's dive into the process, tailored specifically for your Chevy Cruze.

Before you start, make sure your engine is running and the transmission is in 'Park' for automatic models or 'First' for manual. This allows the fluid to circulate and gives you an accurate reading.

Gathering Your Tools

First, ensure you have the necessary tools. You'll need a transmission fluid dipstick, a small funnel, and fresh transmission fluid compatible with your Chevy Cruze (typically Dexron VI). It's also handy to have a helper for this process, as you'll need to measure the fluid while the vehicle is running.

AD
How to Check Transmission Fluid in Your Automatic Car
How to Check Transmission Fluid in Your Automatic Car
2011-2016 Cruze Limited 1.4L PCV System Explained
2011-2016 Cruze Limited 1.4L PCV System Explained
Chevrolet Cruze 2012 Workshop Manual
Chevrolet Cruze 2012 Workshop Manual

Next, locate the dipstick. In the Chevy Cruze, it's usually under the hood, near the center of the engine. It should be easily visible once you've opened the hood and removed the protective cover.

Checking the Fluid Level

The process of checking the fluid level involves several steps. Let's break it down into manageable parts.

Chevrolet Cruze Oil and Filter Change
Chevrolet Cruze Oil and Filter Change
CHEVY CRUZE ATF TRANSMISSION FLUID LEVEL CHECK, CHANGE OR TOP OFF
CHEVY CRUZE ATF TRANSMISSION FLUID LEVEL CHECK, CHANGE OR TOP OFF

Initial Reading

With the engine running and the transmission in the correct gear, pull out the dipstick, wipe it clean, and then reinsert it fully. Wait for a few seconds to allow the fluid to reach its correct level, then remove it again.

The dipstick has 'H' (Hot) and 'C' (Cold) marks. Since your engine is running, you should refer to the 'H' mark. The fluid level should be within the 'H' range. If it's not, you may need to add or drain fluid.

AD

Adding or Draining Fluid

If your fluid level is low, you'll need to add fluid. Using your funnel, slowly pour the appropriate transmission fluid into the dipstick hole until the level reaches the 'Full' mark on the dipstick. Always add fluid a little at a time, checking the level frequently to avoid overfilling.

If your fluid level is high, you'll need to drain some. This should be done carefully by removing the transmission pan drain plug (usually located under the vehicle, towards the rear) and allowing the excess fluid to drain into a container. Be cautious not to let any fluid come into contact with your skin or eyes, as it can be harmful.

Inspecting the Fluid Condition

Once you've checked and adjusted the fluid level, it's important to inspect the condition of the fluid itself. The fluid should be bright red andxdemi[-][-]thick. If it's brown or has a burnt odor, it's time for a transmission service.

AD

Also, check the fluid for any metallic particles or a strong, acrid smell. These can indicate serious internal damage and warrant immediate professional attention.

Reset the 'Service Transmission' Light

After you've completed the fluid check and service, you'll need to reset the 'Service Transmission' light on your dashboard. This light is part of your Chevy Cruze's on-board diagnostics (OBD) system and illuminates when the system detects a problem or when it's time for routine maintenance.

To reset the light, turn the ignition to the 'On' position without starting the engine. Then, press and hold the accelerator pedal to the floor for about 30 seconds and release. Repeat this process three times, turning the ignition off between each. On the fourth time, with the pedal held down, turn the ignition to the 'Start' position and hold it there until the engine starts. Once it does, the 'Service Transmission' light should be reset.

AD

And there you have it! Checking your transmission fluid is an essential part of maintaining your Chevy Cruze. By understanding this process and performing it regularly, you can help prevent major issues and keep your vehicle running smoothly. Happy wrenching!

AD