Easy Guide: Check Your Starter Motor with a Multimeter
Got a vehicle that's refusing to start? The culprit could well be a faulty starter. Before you call a mechanic or invest in a replacement, you can check the starter's condition with a simple device - a multimeter. Yes, you can do it yourself! Let's dive into a step-by-step guide on how to check a starter with a multimeter.
But first, a quick safety brief. Engaging with electrical components requires care. Ensure your vehicle's ignition is off, and the battery is disconnected. Also, on the list of essentials: a multimeter, your car owner's manual, a screwdriver, and some basic electrical knowledge. If you feel hesitant at any point, don't hesitate to consult a professional.
Understanding Your Starter Motor
Before we delve into the multimeter process, let's clarify the starter motor's role. This component is essentially an electric motor that uses power from your car's battery to turn over the engine when you turn the ignition key. It's made up of an electric circuit, including a solenoid, an electrical switch, and a starter drive circuit.
When you turn the ignition key, the starter solenoid activates, closing the starter motor's circuit. This causes current to flow, spinning the motor and engaging the starter drive. If any part of this system malfunctions, your car might not start.
Locating the Starter Motor
Before proceeding, you need to locate the starter motor. Consult your car's owner manual for its exact position, but generally, it's near the transmission and connected to the engine flywheel. It's a large, cylindrical component, usually where you'd place your foot if you were to start the car manually.
Once found, set your multimeter to its highest DC setting (set to measure in 'volts' or 'amps'), and move to the next step.
Testing the Starter Motor's Resistance
With the multimeter set to measure resistance (ohms), touch the black probe to a ground point (any unpainted, bare metal part of the vehicle, or a bolt adjacent to the starter motor) and touch the red probe to the starter motor's terminals. You should see a reading in ohms. This reading is the starter motor's resistance.
Typical readings are around 1-3 ohms. If the reading is much higher or infinite (open circuit), your starter motor might be faulty. Remember, green and orange probes are not used for this test.
Checking the Starter Motor's Solenoid
Now let's check the starter solenoid, a switch that, when activated, completes the starter's electrical circuit. Two types exist: basic and over-center. The methods differ slightly, so let's address both.
Testing a Basic Solenoid
If your multimeter shows an infinite resistance reading after your earlier test, the solenoid might be faulty. Before testing the solenoid, ensure your multimeter's probes will fit into the solenoid switch's small login points.
Connect the multimeter to the solenoid switch, placing the red probe on one post and the black probe on the other. Turn the ignition key to the 'on' position. You should see a reading between 1.5 to 3.5 ohms. If you see an infinite resistance or no continuity, the solenoid is likely bad.
Testing an Over-Center Solenoid
Over-center solenoids have an additional set of wires that engage the starter motor after initially activating the starter. To test this type, first, check for continuity between the battery and the starter's engaged wire, then between the engaged wire and a ground point when the key is in the 'on' position.
You should see a reading of less than 5 ohms if the solenoid works. If you don't? The solenoid might not be engaging correctly. Next, test for continuity between the two posts on the starter motor. If you see a reading, the solenoid's engagement is faulty.
With these steps, you've now checked your vehicle's starter motor and solenoid. If any parts showed signs of malfunction, consider getting a professional repair or replacement to prevent further damage. Safe driving!