Step-by-Step: Change Oil in a Chevy Equinox
Regular oil changes are vital to maintain your Chevrolet Equinox's engine performance and longevity. Here's a step-by-step guide on how to change the oil in your Equinox, tailored for 2010-2020 models. Let's dive in! Remember, safety first, always allow the engine to cool before starting this process.
Before we proceed, make sure you have the following tools and materials ready: an oil filter wrench, a Socket or ratchet with extensions, a funnel, a socket to match your oil pan drain plug (usually 13mm or 14mm), a large drain pan, around 5 quarts of GM/Synthetic 5W-30 oil, and a new oil filter (Chevrolet recommends the ACDelco PF31-12A).
Preparation and Draining the Old Oil
Park your Equinox on a level surface, engage the parking brake, and block the wheels to ensure the vehicle won't move. Put the transmission in 'Park' if you're driving an automatic. Access the underside of your Equinox using a car lift or jack and jack stands.
Locate your oil pan and oil filter at the bottom of the engine, with the filter positioned towards the passenger side. Position your drain pan beneath the oil pan. Using your socket and ratchet, loosen and remove the oil pan drain plug by turning it counterclockwise. Allow the used oil to drain completely, which may take a few minutes.
Removing the Oil Filter
Once all oil has drained, clean the area around the oil filter to prevent any debris from entering your engine. Using your oil filter wrench, rotate the filter counterclockwise and remove it. You may need to press gently on the filter to break the seal.
Before installing the new filter, dip your finger into your new oil and rub it around the new filter's gasket. This ensures the filter is well-lubricated and creates a better seal. Hand-tighten the new filter onto the engine, turning it about 1/4 to 3/4 of a turn after it's seated.
Refilling with New Oil
Replace the oil pan drain plug and tighten it by hand, then secure it with your socket and ratchet. Be cautious not to overtighten; usually, 1/4 to 1/2 of a turn after it's snug is sufficient. Now, locate your oil fill hole on top of the engine, and using your funnel, pour in your new oil, adding it slowly and checking the dipstick frequently.
Once you've added 4 quarts, check the dipstick to ensure you're within the 'FULL' range (around 4.5 quarts for Equinox). If you're close but below 'FULL', add a bit more oil until you're within range. Wipe any spills with a clean, lint-free cloth, and allow the oil to settle for a few minutes.
Resetting the Maintenance Reminder Light and Final Checks
Before starting your Equinox, reset the maintenance required light. For models equipped with OnStar, you'll need to call OnStar at 1-866-ONSTAR (1-866-667-8274) to have them reset it. For other models, consult your owner's manual for specific instructions.
Start your engine, allowing it to run for about a minute, then turn it off. Check for any leaks beneath your Equinox, especially around the oil pan and filter. Using your dipstick, recheck the oil level, and add more oil if necessary to remain within the 'FULL' range.
Remember, it's crucial to monitor your oil level regularly and change your oil filter and oil at recommended intervals to keep your Chevrolet Equinox in top shape. Happy driving!