How to Change Tap: Easy Steps for Every Home
Changing a tap can seem daunting, but with the right guidance, it's a straightforward DIY project. This guide will walk you through the process, ensuring you have a functional and stylish faucet in no time.
Before you start, gather your tools: adjustable wrench, Allen wrench (or hex key), channel-lock pliers, putty knife, and Teflon tape. Also, have a towel or bucket handy to catch any water drips. Now, let's dive into the step-by-step process.
Preparation and Removal of the Old Tap
Begin by turning off the water supply to the faucet. Find the valves beneath the sink, usually behind access panels, and turn them clockwise until they stop. Then, open the faucet to release any remaining water pressure.
Next, disconnect the water supply lines from the tap. Use channel-lock pliers to unscrew the nuts connecting the lines. Be gentle, as these parts can be fragile. Once disconnected, remove the faucet from the sink using an adjustable wrench to loosen the mounting nuts.
Removing the Old Faucet Base
With the faucet body removed, you'll see the base plate attached to the sink. Use an Allen wrench or a screwdriver to remove the mounting screws. If the plate is rusted in place, use a putty knife to gently pry it off.
Caulks or old plumber's putty around the faucet hole can be removed with a putty knife. Be careful not to scratch the sink surface. Once the area is clean, you're ready to install your new tap.
Installing the New Tap
Start by applying a bead of plumber's putty around the base of the new faucet. This will create a watertight seal and also keep the faucet steady during installation. Fit the faucet base onto the sink hole, pressing gently but firmly to make sure the putty seals.
Insert and secure the faucet from below using the mounting nuts and washers provided with your new tap. Tighten just enough to secure the faucet, but be careful not to overtighten and damage the sink. Some taps may require you to use an Allen wrench or a specialized tool for this step.
Connecting the Water Supply Lines
Wrap the threads of the faucet's water inlet ports with Teflon tape to ensure a watertight connection. Use about three wraps in a clockwise direction, overlapping each layer by half. This will help prevent leaks later on.
Connect the water supply lines to the faucet's inlet ports. Hand-tighten these connections to start, then use a wrench to snug them securely. Be cautious not to overtighten and damage the faucet or supply lines.
Testing the New Tap
Once everything is connected, turn the water supply valves back on by turning them counterclockwise. Check for any leaks around the faucet base, where the supply lines connect, and under the sink. If there are no leaks, your new tap is now ready for use.
Over time, you may notice water spots or scale buildup on your new faucet. Regular cleaning with a mild soap and warm water, followed by a gentle buff with a soft cloth, will keep your tap looking like new.
Congratulations! You've successfully changed your tap. Enjoy your new faucet and the satisfying feeling of DIY success. If you encounter any issues or have further questions, don't hesitate to seek help from a local plumber or hardware store professional.