how to change subaru forester headlight

How to Change Subaru Forester Headlights

By David Thomas
AD

Is your Subaru Forester's headlight giving you trouble with its dim or foggy light? It might be time to replace it. This guide will walk you through the process of how to change a Subaru Forester headlight, ensuring your safety and visibility on the road.

Before you start, gather the necessary tools and materials. You'll need a 10mm socket wrench, a flathead screwdriver, a T-20 Torx bit, and a new headlight assembly. Also, make sure you're working in a well-lit area, and never attempt this repair at night.

Assessing the Damage

First, take a close look at your headlight. Verify that the issue is indeed the headlight itself and not another part of the lighting system, like a faulty bulb or broken connector.

AD
How to Change Your Headlights (Subaru Forester)
How to Change Your Headlights (Subaru Forester)
How to change replace Headlight bulb in Subaru Forester. 2008–2013
How to change replace Headlight bulb in Subaru Forester. 2008–2013
the engine compartment of a car with its hood open and wires attached to it's side
the engine compartment of a car with its hood open and wires attached to it's side

If the headlight's housing is cracked or damaged, you'll likely need a replacement. Minor scratches or fogginess can often be fixed with a headlight restoration kit, but severe damage requires a new part.

Preparing the Forester

Before you start, disengage the negative battery terminal to prevent any electrical shorts. Then, use the 10mm socket wrench to loosen and remove the bolts holding the bumper cover in place. Slide the cover up slightly, then locate the retaining screws for the headlight and remove them with the T-20 Torx bit.

2014-2018 Subaru Forester - Headlight - Testing After Changing Burnt Out Light Bulbs
2014-2018 Subaru Forester - Headlight - Testing After Changing Burnt Out Light Bulbs
How to Replace Headlight Bulbs 11-16 Subaru Impreza
How to Replace Headlight Bulbs 11-16 Subaru Impreza

Now, disconnect the electrical connectors from the back of the headlight. You might need to use a flathead screwdriver to gently pry apart the connector tabs. Once disconnected, carefully pull the headlight out of its housing.

Installing the New Headlight

Position the new headlight in the housing, lining up the tabs on the back with the slots in the housing. Reach behind the headlight and reconnect the electrical connectors. Ensure they're fully seated and latched.

AD

Replace the retaining screws and tighten them with the T-20 Torx bit. Remount the bumper cover and secure it with the bolts you removed earlier. Finally, reengage the battery terminal.

Testing the New Headlight

With the new headlight installed, it's crucial to test it to ensure it's working correctly. Turn on your headlights and check that both the low beam and high beam are functioning as they should.

Take your Forester for a test drive, including driving in both daylight and nighttime conditions, to ensure the new headlight provides adequate visibility. If the light isn't illuminating as expected, double-check that all connections are secure, and there are no other issues with your vehicle's electrical system.

AD

Regular Maintenance

To prolong the life of your new headlight, perform regular maintenance. Inspect the headlight and connectors for signs of damage or wear. Keep the headlight lens clean and consider applying a UV protectant to prevent future fogging or damage from the sun.

Remember, replacing a headlight is a straightforward job, but if you're unsure about any part of the process, don't hesitate to consult a professional mechanic.

And there you have it - your Subaru Forester's headlight is as good as new. Safe driving!"

AD
AD