"Change Springs on Struts: A Simple Step-by-Step Guide"
Struts, an integral part of a vehicle's suspension system, can become worn out over time, resulting in a less than comfortable ride. Among their components, the springs may need replacing due to damage or aged deterioration. Here's a step-by-step guide on how to change springs on struts, ensuring your vehicle's suspension is in prime condition.
Before we dive into the process, safety precautions are vital. Ensure your vehicle is securely jacked up, and use jack stands for stability. Always disengage the vehicle's ignition and put it in 'Park' or 'Neutral', setting the parking brake. Wear appropriate gloves for handling springs, as they can be sharp and cause injury.
Gather Your Tools and Replacements
Before starting the process, collect all necessary tools and parts:
- Floor jack and jack stands
- Lug nut wrench
- Socket set
- Box-end wrenches
- Crescent wrench or adjustable wrench
- Pry bar (you might need this to remove old springs)
- New strut springs
Identify Your Spring Type
Before removing the old springs, identify the type you have. There are two main types:
- Coil-over Strut Spring: This type is attached directly to the strut.
- Separate Spring: Found on vehicles with a separate upper strut mount, these springs are not attached to the strut.
Preparation for Removal
Use a lug nut wrench to loosen the lug nuts on the tire, but don't remove them completely. This makes it easier to lower the vehicle onto jack stands later. Next, use a floor jack to lift the vehicle and support it securely with jack stands.
Dismantle the Strut Assembly
Now that the vehicle is secure, begin removing components from the strut assembly:
Old Spring Removal
Disconnect the negative battery terminal to prevent electrical shorts. Then, remove the tire and brake caliper, suspending it with a coat hanger or a similar tool. You may need to use a pry bar to disconnect the old spring from the strut mount, as it often gets stuck due to corrosion or age.
Remove the Old Strut Assembly
Once the spring is off, use a box-end wrench or socket to loosen and remove the strut mount nuts. Then, carefully lower the strut assembly out of the vehicle. If your vehicle has a separate bump stop, this is also part of the strut assembly and should be removed with the strut.
Install the New Strut Springs
With the old strut assembly out, it's time to install the new strut springs:
Inspect the Mounts and Bearings
Before installing the new strut assembly, inspect the strut mounts and bushings for wear or damage. Replace them if necessary to ensure optimal performance of your new springs.
Install the New Strut Assembly
Align the new strut assembly's upper mount with the corresponding hole in the vehicle's body or mount. Insert and secure it, ensuring it's tightly fastened with the correct specified torque. Then, lower the entire vehicle back down using the floor jack.
Final Touches and Safety Checks
After reinstalling the tire and brake caliper, replace the lug nuts and tighten them by hand. Lower the vehicle completely and remove the jack stands. Tighten the lug nuts again using the lug nut wrench and give them a final tightening with the socket and standard wrench.
Engage the parking brake, then try moving the vehicle slightly to engage the suspension and settle the new springs into place. After ensuring everything feels right, give your new strut springs a test drive at low speeds, gradually increasing to normal driving conditions.
By learning how to change springs on struts, you've not only improved your vehicle's suspension, but you've also gained confidence in handling essential maintenance tasks. Regularly check your vehicle's suspension system for any signs of wear, and keep your 'spring' in your step knowing your vehicle is well-maintained.