how to change oil in a honda civic

"How to Change Oil in a Honda Civic: DIY Guide for Your 2022 Model"

By Emily Miller
AD

When it comes to essential car maintenance, changing the oil in your Honda Civic should not be overlooked. This routine task ensures your vehicle's engine stays in top-notch condition, improving performance and longevity. Today, we'll guide you through the process of changing the oil in a Honda Civic, complete with step-by-step instructions and vital tips.

Before we begin, ensure you've gathered the required materials - 5W-20 or 5W-30 synthetic motor oil (consult your owner's manual for the exact type), a new oil filter, a wrench (14mm), an oil filter wrench, a funnel, an oil pan, and latex or nitrile gloves to protect your hands.

Preparation and Positioning

First, locate your Honda Civic's engine oil pan, typically positioned at the bottom and near the center of the engine.

AD
oil change for honda civic
oil change for honda civic
2006-2011 Honda Civic OIL CHANGE | Easy and Simple
2006-2011 Honda Civic OIL CHANGE | Easy and Simple
How to Change Engine Oil and Filter In 2012 Honda Civic 2006-2015
How to Change Engine Oil and Filter In 2012 Honda Civic 2006-2015

Next, drive your car onto a flat surface and allow the engine to run for about 15 minutes to warm up the oil, ensuring it drains smoothly. Turn off the engine and wait for about 30 minutes to let the oil cool and settle.

Draining the Old Oil

Position your oil pan underneath the oil drain plug, located at the bottom of the oil pan. Carefully loosen and remove the plug using your 14mm wrench, allowing the old oil to drain completely.

Oil Change
Oil Change
HOW TO: Change Oil on a 2010 Honda Civic.... With Mom
HOW TO: Change Oil on a 2010 Honda Civic.... With Mom

Once the oil has finished draining, replace the oil drain plug by hand, ensuring it's tightened snugly but not overly tight (around three to four turns from fully seated).

Removing and Replacing the Oil Filter

Locate the oil filter, usually positioned on the side of the engine. Using the oil filter wrench, carefully loosen and remove the filter. Remember to recycle the old filter responsibly.

AD

Rub a small amount of new motor oil around the gasket of the new oil filter before screwing it onto the engine by hand, ensuring it's tightened snugly (around three-quarters to one turn from fully seated).

Adding New Oil

Locate the oil fill hole on top of the engine and use a funnel to pour the required amount of new motor oil into the engine. Check your owner's manual for the exact amount your vehicle requires.

Slowly and carefully pour the oil into the engine, allowing the oil to settle between additions. Once the required amount has been added, reinsert the oil fill cap.

AD

Checking the Oil Level

Allow the oil to settle for a few minutes, then locate the oil dipstick, pull it out, wipe it clean, and reinsert it. Pull it out again to check the oil level. The level should be between the FULL and ADD marks on the dipstick.

If necessary, add more oil in small amounts, allowing it to settle between additions until the correct level is reached.

A job well done! Remember to properly dispose of the used oil and filter at a designated recycling center. Next, reset your car's maintenance reminder light and consult your owner's manual for specific instructions on how to do so. Safe driving, and happy wrenching!

AD
AD