How To Change Oil In Your Craftsman Push Mower: A Step-By-Step Guide
When it comes to maintaining your outdoor equipment, regular upkeep is key. One lazily overlooked task is oil change on your trusty Craftsman push mower. While DIY oil changes might seem daunting, fear not, as we're here to guide you through the process step-by-step.
Regular oil changes, around every 25-50 hours of operation or annually, ensure your mower's engine stays in tip-top shape. But how do you change the oil on a Craftsman push mower? Let's dive right in.
Gather Your Tools and Materials
Before you start, make sure you have all the necessary tools and materials.
**Tools needed:** - Socket wrench with an 13mm socket - Oil filter wrench - Funnel - Oil catch pan - Gloves - Rags or shop towels - Torque wrench (optional) **Materials needed:** - Vegetable oil or SAE 10W-30 motor oil (consult your mower's manual for the exact type) - New oil filter that matches your mower's specifications
Preparation
First, ensure your mower has cooled down for at least 30 minutes to avoid any risks.
Now, tip your mower's lawnmower deck on one side to allow the oil to gather at the oil pan.
Drain the Oil
Using your socket wrench, loosen and remove the oil pan's drain plug. Let the oil drain into your catch pan.
Once finished, wipe clean the drain plug and oil pan, then reattach and tighten the plug, using a torque wrench not exceeding 25 lb-ft (34 Nm).
Replace the Oil Filter
Position your catch pan underneath the oil filter. Using your oil filter wrench, loosen and remove the oil filter.
Rub a light coat of new oil around the gasket of the new oil filter. Installation is as simple as screwing it on by hand only. No oil filter wrench needed here!
Add New Oil
With everything secure and tight, grab your funnel and begin slowly pouring the appropriate amount of oil into the oil fill port.
**Pro tip:** Always consult your mower's manual for the exact amount of oil needed.
Finalize the Process
After adding the correct amount of oil, replace the oil fill plug.
Monitor your dipstick to ensure the oil level is within the full range. If needed, adjust the oil level by adding more oil.
Safety first, run your mower engine for about a minute or two, allowing the new oil to circulate and coat the engine.