How to Change Oil on 2016 Honda Civic: Step-by-Step Guide
Keeping your 2016 Honda Civic's engine in peak condition involves regular oil changes. The manufacturer recommends changing the oil every 7,500 to 8,000 miles, or once a year, whichever comes first. This comprehensive guide will walk you through the process, ensuring your Civic's engine remains well-lubricated and high-performing.
Before we start, gather your tools and materials. You'll need a 16mm socket wrench, an oil filter wrench, 5W-20 or 5W-30 synthetic motor oil (depending on your Civic's trim and driving conditions), a new oil filter, and a drain pan to catch the old oil. Ensure you have the correct oil type and volume - typically, 3.5 to 4 quarts are needed for a Civic hatchback or sedan.
Preparation
트의 Conditional: Before you begin, make sure your car is parked on a level surface and has cooled down to prevent any burns. Locate the oil pan under your car, near the bottom of the engine.
It's also a good idea to put on gloves to protect your hands from oil and dirt. Additionally, have some rags or shop towels on hand to clean up any spills.
Draining the Old Oil
Using the 16mm socket wrench, loosen and remove the oil pan drain plug located at the bottom of the oil pan. Position your drain pan underneath to collect the old oil.
Allow the oil to drain completely. This may take a few minutes. Once all the oil has drained, wipe the area clean and reattach the drain plug, securing it tightly but being careful not to overtighten.
Removing and Replacing the Oil Filter
Position the oil drain pan underneath the oil filter. Using the oil filter wrench, turn and remove the oil filter by hand if possible. If it's too tight, the wrench may help, but be cautious not to damage the filter.
Before installing the new oil filter, rub a small amount of new oil around the gasket to create a better seal. Screw on the new filter by hand, turning it clockwise until it's snug, then about three-quarters of a turn counterclockwise. This ensures the filter is not overtightened.
Refilling the Engine with New Oil
Now that the old oil and filter are removed, it's time to refill your engine with fresh oil. Locate the oil fill hole on top of the engine and remove the oil cap.
Pour the recommended amount of new oil into the engine. Monitor the dipstick as you pour to avoid overfilling. Once you've added the correct amount, replace the oil cap.
Checking the Oil Level
Allow the oil to settle in the engine for a few minutes, then recheck the oil level using the dipstick. Wipe the dipstick clean, insert it all the way back into the oil fill hole, then pull it out again.
Check the oil level on the dipstick. It should fall within the "FULL" range on the dipstick. If it's below this range, add more oil in small increments until it falls within the "FULL" range. If it's above this range, you may have overfilled, and you'll need to drain some oil to avoid overfilling.
Resetting the Maintenance Minder
After changing the oil, it's essential to reset the Maintenance Minder system in your Civic. This system tracks routine maintenance and will remind you when services are due based on driving conditions.
Reset the Maintenance Minder by turning the ignition to the "ON" position without starting the engine. Press and hold the "SELECT/RESET" button for about 20 seconds until the "MAINTENANCE MINDS" message appears on the display. Press the "SELECT/RESET" button once to confirm, and the system will reset.
Congratulations, you've successfully changed the oil in your 2016 Honda Civic! Driving off with clean, fresh oil ensures your engine remains lubricated and running efficiently. Regular oil changes are crucial for maintaining your Civic's high performance and longevity.