how to change nissan altima oil

How to Change Oil in Your Nissan Altima

By Joshua Clark
AD

Regular oil changes are crucial for maintaining the performance and longevity of your Nissan Altima. This guide will walk you through the process of changing your Altima's oil, ensuring you stay on top of your vehicle's maintenance.

The ideal frequency for an oil change varies based on your driving conditions, so we recommend consulting your Altima's owner's manual. On average, however, you should change your oil every 5,000 to 7,500 miles for conventional oil and every 5,000 to 10,000 miles for synthetic oil.

AD
How to change oil in a 2020 Nissan Altima
How to change oil in a 2020 Nissan Altima
How to Change Power Steering Fluid Nissan Altima | 4 Quick Steps (2026)
How to Change Power Steering Fluid Nissan Altima | 4 Quick Steps (2026)
2007 To 2012 Nissan Altima How To Change Engine Oil & Filter (2.5L I4) - Quick & Easy Version
2007 To 2012 Nissan Altima How To Change Engine Oil & Filter (2.5L I4) - Quick & Easy Version

Gathering Necessary Materials and Preparation

Before you start, gather the following materials to ensure a smooth oil change process:

How To Replace Engine Oil 98 -01 Nissan Altima
How To Replace Engine Oil 98 -01 Nissan Altima
the engine and fuel compartment of a car with text overlay that reads 2013 to 2018 nissan altima how to change engine oil & filter
the engine and fuel compartment of a car with text overlay that reads 2013 to 2018 nissan altima how to change engine oil & filter

  • Oil filter - Choose a filter that matches your vehicle's make and model.
  • Oil - Use the type and amount specified in your owner's manual.
  • Wrench - A 13mm or 14mm socket wrench for draining the oil pan.
  • Oil filter wrench - To loosen and remove the oil filter.
  • Funnel - To guide the new oil into the oil fill hole.
  • Oil catch pan - To collect the old oil.
  • Gloves - To protect your hands from oil spills.
  • Shop towels or rags - To clean up any spills.

Once you have all the materials, prepare your Altima by parking it on a level surface and allowing the engine to run for about 15 minutes to warm up the oil.

AD

Locating the Oil Drain Plug and Filter

The oil drain plug and oil filter are located at the bottom of the vehicle, accessible from underneath. Use a lift or safely jack up the Altima to access this area. Refer to your owner's manual for the specific location of these components.

AD

Locate the oil drain plug, usually a large bolt, and place your oil catch pan beneath it. Position the oil filter wrench around the oil filter, which should be close to the drain plug.

Draining the Oil and Removing the Oil Filter

Using your socket wrench, slowly loosen the oil drain plug by turning it counterclockwise. Be cautious, as the plug and pan will be hot. Once the plug is loose, allow the old oil to drain completely into the catch pan.

AD

After all the oil has drained, remove the oil drain plug completely and wipe it clean. Inspect the drain plug's washer; if it is compressed or shows signs of damage, replace it with a new one.

With the oil drained, move on to the oil filter. Using the oil filter wrench, turn the oil filter counterclockwise to loosen and remove it. As the oil filter comes off, old oil may leak out, so maintain your grip with the wrench.

Preparing the New Oil Filter and Fill

Before installing the new oil filter, lightly coat its rubber gasket with new oil. This helps create a better seal and makes it easier to remove the filter during future oil changes.

Screw the new oil filter onto the oil filter mount by hand, turning it clockwise until the gasket just barely makes contact with the engine block. Then, turn the oil filter an additional ¾ to 1½ turns, following the manufacturer's instructions.

Adding the New Oil

Reinstall and tighten the oil drain plug, using the torque specification found in your owner's manual (usually around 25-35 ft-lbs for the Altima). Allow the oil to settle for a minute or two, then check the oil level using the dipstick.

Locate the oil fill hole on top of the engine, marked with a cap or yellow ring. Using a funnel, slowly pour the recommended amount of new oil into the engine, checking the oil level consistently with the dipstick. Be careful not to overfill the engine.

Checking for Leaks and Resetting the Maintenance Light

Start the engine and let it run for about a minute to allow the new oil to circulate. Turn off the engine and wait a few more minutes for the oil to settle again. Inspect the area around the oil drain plug and oil filter for any leaks.

If no leaks are present, recheck the oil level and add more oil if necessary. Once you're satisfied with the oil level, clear the Maintenance Required light on your Altima's dashboard by turning the ignition to the "ON" position without starting the engine. Press and hold the "TRIP" button until the light resets.

Before hitting the road, allow the engine to run for a few more minutes and recheck for any potential leaks. If everything looks good, safely lower your Altima and enjoy your smooth oil change. Make a note of the mileage and date of this oil change for future reference.

Regular oil changes are vital for maintaining your Nissan Altima's performance and fuel efficiency. By following this guide, you've taken an essential step in caring for your vehicle. Happy driving, and remember that if you have any concerns or prefer professional assistance, visit your local authorized Nissan service center.

AD