How to Change Filter on Elkay Water Fountain
Regular maintenance of your Elkay water fountain is crucial to ensure a steady supply of clean, fresh water. One vital aspect of this maintenance is replacing the filter to maintain water quality and fountain performance. This guide will walk you through the process of changing the filter on your Elkay water fountain.
Before we start, ensure you have the following materials ready: a new Elkay cambios filter, a Phillips #1 screwdriver, and a towel to prevent water spills. Let's dive into the step-by-step process.
The Removal Process
Accessing the Filter Housing
Start by turning off the water source to your fountain. This is usually a valve under the sink or behind the fountain. This prevents water from flowing while you're replacing the filter.
Next, locate the filter housing on your Elkay fountain. It's typically found at the back of the unit. Use your Phillips #1 screwdriver to remove the two screws that secure the access panel. Carefully remove the panel to expose the filter housing.
Removing the Old Filter
You'll see a metal bracket holding the old filter in place. Release the bracket by lifting it up and away from the filter. This should expose the filter cartridges.
Grasp the filter cartridge with both hands and gently twist it counterclockwise. You should feel it release from the housing. Continue to turn it slowly until it's free, then pull it out. You may want to have your towel ready, as some water might spill out.
The Installation Process
Preparing the New Filter
Unwrap your new Elkay cambios filter and ensure it's dry. If it's not, gently wipe it with a towel to remove any condensation.
Inspect the O-ring on the new filter. If it looks dry or damaged, lubricate it with a bit of mineral oil or use a new O-ring found in the filter kit.
Installing the New Filter
Position the new filter into the housing, ensuring the arrow on the filter points in the direction of water flow (usually indicated by an arrow on the housing or in your fountain's instructions).
Gently push the filter into the housing and rotate it clockwise until it's securely fastened. You should feel it click into place.
Reassembling the Fountain
Replace the metal bracket, ensuring it's properly secured over the new filter. Then, replace the access panel and secure it with the two screws you removed earlier.
Turn the water valve back on and give your fountain a few minutes to prime. Once it's working again, check for any leaks around the filter housing. If all looks good, you've successfully replaced the filter in your Elkay water fountain.
Regularly changing your fountain's filter, as recommended by Elkay, usually every 6 to 12 months depending on usage, will help maintain the quality and freshness of your water. Happy hydrating!