how to change filter in whirlpool fridge

Whirlpool Fridge Filter Change: A Step-by-Step Guide

By Kevin Thompson
AD

Before you begin, make sure you have the following items on hand: a new filter (ensure it's compatible with your Whirlpool fridge model), a screwdriver, and a few clean cloths or towels. The process is straightforward, but it's always a good idea to read the full instructions first.

Preparation and Safety

Before you start, turn off and unplug your fridge to ensure your safety. Allow the fridge to defrost for a few hours to prevent any water spills during the filter change. Also, prepare your work area by laying down clean towels to catch any spills.

Check your fridge model number. The filter replacement process may vary slightly depending on your model. You can find the model number on a tag located at the bottom or back of your fridge. If you're unsure, always consult your user manual or contact Whirlpool's customer service.

Locating the Filter

The filter in your Whirlpool fridge is usually located in one of three places: in the fresh food compartment, behind the bottom right vegetable drawer, or at the back of the fridge. Find the filter in your fridge by referring to your user manual or looking for a Donaldson filter logo.

Once you've located the filter, note the way it's positioned. It's important to install the new filter in the same orientation for it to work correctly.

Removing the Old Filter

Start by removing the grill or cover that houses the filter. You may need to use a screwdriver to remove screws or simply lift the cover off.

Twist the old filter counterclockwise to loosen it. Turn it gently to avoid breaking it. Once it's loose, pull it out and discard it. Remember the position and orientation of the old filter for when you install the new one.

Installing the New Filter

Before installing the new filter, rinse it with warm water to remove any dust or debris. This will help it work more efficiently right from the start.

Position the new filter in the same way the old one was. Most filters have arrows that indicate the direction of airflow. Ensure these arrows point towards the inside of the fridge.

Securing the New Filter

Push the new filter firmly into place. You should feel it lock into position. Then, twist the filter clockwise until it's securely tightened and level with the filter housing.

Reattach the grill or cover you removed earlier. Ensure it's securely fastened back in place. If you removed screws, make sure they're tightly replaced.

Testing the New Filter

Plug your fridge back in and turn it on. Allow it to run for about five minutes to test the new filter.

You should hear a slight gurgling sound as air passes through the new filter. If you don't hear this sound or notice reduced airflow, you may have installed the filter incorrectly. Check the filter's position and orientation and try again.

Congratulations, you've successfully changed the filter in your Whirlpool fridge! Regular filter changes will help maintain your fridge's performance and ensure the air inside remains fresh. Remember to change your filter every six months for optimal results. If you ever feel unsure about any step, don't hesitate to consult your user manual or contact Whirlpool's customer service for assistance.

How To Reset Filter Light On Whirlpool Refrigerator
How To Reset Filter Light On Whirlpool Refrigerator
a person is holding an electric toothbrush in front of a water filter
a person is holding an electric toothbrush in front of a water filter
How To Change Ice Maker Filter On Whirlpool – Storables
How To Change Ice Maker Filter On Whirlpool – Storables
EveryDrop Water Filter #4 Installation
EveryDrop Water Filter #4 Installation
How to Replace a Filter on Whirlpool W10407342B side-by-side refrigerator
How to Replace a Filter on Whirlpool W10407342B side-by-side refrigerator
AD