How to Change Battery on Red Dot Sight
If you're an avid shooter or a regular at the shooting range, you've likely encountered a situation where your red dot sight stops working due to a drained battery. It's not the end of your range session, though - read on to learn how to change the battery on your red dot sight, getting you back on target in no time.
Before we dive into the step-by-step process, let's quickly cover why red dot sights use batteries. Red dot sights use an illuminated reticle for aiming, and this illumination requires power. Most red dot sights use lithium coin cell batteries, typically CR2032 or CR1632, which last a considerable amount of time before needing replacement. When the battery runs out, the illumination cuts off, rendering your sight useless. Now, let's get that battery replaced.
Preparation: Tools & Safety
Before you start, ensure you have the right tools and follow proper safety procedures. You'll need a small flathead screwdriver or a coin with a similar size to the battery, as well as a new battery of the specified type. Always ensure your firearm is unloaded and store it in a safe place while working on your sight.
It's also a good idea to work in a well-lit area with plenty of space to layout your components. This prevents damage to components and makes the process more straightforward.
Locating the Battery Compartment
Battery compartments on red dot sights typically have one of two types of covers. Some sight batteries are accessed by removing a small screw and lifting off the cover, while others have a simple slide or push mechanism.
If your sight has a screw, use your screwdriver to remove it. For slide or push mechanisms, carefully pry it open using your fingers or a small tool. Be gentle and avoid exerting excessive force to prevent damage to the cover or sight.
Removing the Old Battery
Once you've accessed the battery compartment, you'll see the old battery. It's usually held in place by a small clip or a battery contact at the bottom of the compartment. Gently pull up on the battery to release it from the clip or contacts, taking care not to damage the electrical contacts.
If the battery is stuck, try rotating it slightly while pulling upwards. Sometimes, the battery may be aligned with the contacts in such a way that it won't budge. A slight rotation can break the seal and allow you to remove it.
Inserting the New Battery
Before inserting the new battery, ensure it's the correct type specified in your sight's manual. Most red dot sights use CR2032 or CR1632 batteries, but it's crucial to check your specific sight. Align the positive side (usually marked with a "+" or "+") of the battery with the positive contact in the compartment.
Gently press the new battery into place, ensuring it makes good contact with the electrical contacts. You should feel a slight click as the battery is seated correctly. If you're using a sliding or push mechanism, carefully push the cover back into place. If your sight uses a screw, replace it and tighten it gently.