Step-by-Step Guide: How to Change Battery in Chrysler 300 key fob
Have you found that your Chrysler 300 key fob isn't working as it should? The batteries in your keyless entry remote might be the culprit. Replacing them is a straightforward process that you can do at home, saving you time and money.
Before you start, make sure you have the right battery. The Chrysler 300 uses a single 2032 coin cell battery, which is easy to find at most stores. Also, keep in mind that while this process is straightforward, it can vary slightly depending on the year of your vehicle. For this guide, we'll focus on the 2011-2021 models.
Locating the Battery Compartment
The first step is to access the battery compartment. On the back of your key fob, you'll find two plugs that hold the key fob together. For the 2011-2014 models, these plugs are black, while for the 2015-2021 models, they're gray.
Using a flathead screwdriver or a coin, carefully pry the plugs out. You should hear a slight 'click' as each plug releases. Once both plugs are out, you can separate the key fob into two halves.
Removing the Old Battery
Now that you have access to the battery compartment, you can remove the old battery. It's a small, round battery with a negative (-) and positive (+) terminal. The positive terminal is the one closest to the button side of the key fob.
To remove the battery, use your fingernail or a coin to carefully pry it up from the positive terminal. The battery should lift out easily. If it's stuck, you might need to use a small tool like a tweezers to gently lift it out. Make sure not to touch the terminals to prevent short-circuiting.
Inserting the New Battery
With the old battery removed, it's time to insert the new one. The new battery should have the same positive and negative terminal markings as the old one. Make sure to align the battery correctly before inserting it.
Press the battery down firmly, but not too hard, to secure it in place. The battery compartment should snap shut with the new battery inside. If it doesn't, double-check that the battery is aligned correctly and that nothing is blocking it from seating properly.
Reassembling the Key Fob
Now that the battery is securely in place, you can reassemble the key fob. Line up the two halves and align the tabs on one half with the slots on the other half.
Press the halves together firmly until you hear a 'click'. This indicates that the key fob is securely back together. The gray plugs should snap back into place easily. If they don't, double-check that the key fob halves are fully aligned.
Testing the New Battery
With the key fob reassembled, it's time to test the new battery. Unlock your car doors using the keyless entry buttons on your key fob. If the new battery is properly installed, your car doors should unlock as they did before.
If your key fob is still not working, double-check that the battery is installed correctly. It's possible that the battery has a reversed polarity. If that's the case, remove the battery and reinstall it with the positive and negative terminals switched. If your key fob still isn't working, it might be time to consider professional help.
Remember, changing your Chrysler 300 key fob battery is a straightforward process, but it's important to take your time and do it correctly to avoid damaging the key fob. If you're unsure at any point, don't hesitate to consult a professional.