Discover Booklet Binding: How to Tie with Ribbon
Once you've crafted your booklet, the next step is to give it a polished, professional look with a ribbon binding. This DIY project is easier than you might think, and requires minimal tools. Here's a step-by-step guide to help you bind your booklet with a ribbon.
Before you begin, you'll need to gather some materials: your booklet, a ribbon (width depends on your booklet size, but ³⁄₈" is a common choice), scissors, a bone folder or spoon for creasing, a needle, and matching thread.
The Preparation
The first step is to ensure your booklet is ready for binding. Make sure the pages are neat, and the covers are smooth.
Choose a ribbon that complements your booklet's cover and theme. The width of the ribbon should ideally be one-third the height of your booklet.
Measuring the Ribbon
Determine the length of ribbon you need. To find this, measure around your booklet, from spine to front cover, then double this measurement to allow for both sides.
Add ³⁄₄" to 1" to this total for overlap at the beginning and end. Cut your ribbon to this length.
Creating Guides
Use a ruler and a pencil to mark guidelines on the inside front and back covers where your ribbon will go. These marks should be ³⁄₄" from the top and bottom edges.
Use your bone folder or spoon to gently crease the covers along these lines. This will ensure your ribbon sits nicely and doesn't show from the front.
The Binding Process
Now your booklet is ready for the ribbon. Start by threading your needle with matching thread.
On the inside front cover, start stitching at the bottom guideline. Knot your thread at the bottom inside corner, then bring the needle up through the bottom crease.
Stitching the Ribbon
Fold the ribbon in half lengthwise, with the shiny side out. Place the folded edge along your crease. Holding the ribbon in place, bring your needle up through the covered edge of the ribbon.
Continue stitching up the crease, catching only the ribbon, not the paper. Keep the stitching close together, about ³⁄₁₆" apart.
Finishing the Stitching
Once you've stitched up to the top guideline, knot your thread securely on the inside of the cover. Use scissors to trim any excess thread.
Repeat this process on the inside back cover. When you're done, your ribbon should be securely stitched to both covers, with no stitches visible from the front.
Securing the Ribbon
Now, it's time to secure the loose ends of your ribbon. Fold the ribbon in half, with the loop at the spine. Take the loose ends and loop them through the folded ribbon, pulling them through the loop.
This should create a secure knot at the spine. You can trim the excess ribbon at this point, leaving enough to tie a bow at the front.
Your booklet is now bound with a professional-looking ribbon. This finishing touch not only makes your booklet more pleasing to the eye, but also helps keep pages from falling out. Happy binding!