how to attach furring strips to block wall

Attach Furring Strips to Block Wall: Expert Guide

By James King
AD

Attaching furring strips to a block wall is a common way to prepare a surface for finishing, improve insulation, or create space for electrical wiring. If you're planning to attach drywall, paneling, or another material to the wall, this step ensures a smooth, secure surface to work on. Here's a comprehensive guide on how to do it right, along with common mistakes to avoid.

Before you start, gather your materials: furring strips (typically 1"x3" or 1"x4" dimensional lumber), screws or nails (ensure they're long enough to penetrate the block and secure into the mortar joint), a tape measure, a level, a speed square, and a drill or hammer, depending on your chosen fastener.

Preparation of the Block Wall

Before attaching furring strips, prep your block wall to ensure a solid foundation for your project.

AD
How to put drywall over garage uneven concrete wall?
How to put drywall over garage uneven concrete wall?
The Hows and Whys of Furring Strips. Part-1
The Hows and Whys of Furring Strips. Part-1
Using Furring Strips to Attach Drywall to Block Walls
Using Furring Strips to Attach Drywall to Block Walls

Clean the Wall

Remove any debris, dust, or remnants of previous materials from the wall. Inspect the wall for damaged or loose blocks, and repair them as necessary.

Check Plumb and Level

Ensure your wall is plumb (vertical) and level (horizontal). Adjust any issues with shims during the furring strip installation.

Appplying Furring Strips To A Concrete Wall
Appplying Furring Strips To A Concrete Wall
What Are Furring Strips? [Complete Guide]
What Are Furring Strips? [Complete Guide]

Attaching Furring Strips

Once your wall is prepped, it's time to attach the furring strips. Remember, the goal is to create a flat, even surface, so precision and consistency are key.

Mark the Stud Placement

Using your tape measure and level, mark the center of each block on your wall. This will help you space the furring strips evenly and provide a secure battalion for the fasteners.

AD

For 12-inch center-to-center block, the studs should be placed 12" on center (OC). For 16-inch or 24-inch centers, adjust your measurements accordingly. Aim for a mix-between where possible; 24" OC is mostly reserved for heavy loads like brick veneers.

Attach the Furring Strips

Start by placing your first furring strip at the bottom of the wall, leveling it as you go. Use a speed square to ensure the strip is properly aligned. Fasten it using screws or nails at each mark.

Continue placing and attaching furring strips, spacing them according to your earlier marks. Ensure each strip is level and plumb before securing. You can use a level tool or a laser level for accuracy.

AD

Filling Gaps and Final Prep

Once all strips are attached, fill any remaining gaps with insulation or fireblock material. This prepares your wall for the next phase of your project and adds a layer of safety.

Now that your furring strips are securely attached, your block wall is ready for the next step, whether it's adding insulation, running electrical wires, or installing drywall. The key to successful furring strip attachment is accuracy and consistency, so take your time, measure twice, and cut or drill once.

When attaching materials to the finished wall, ensure your fasteners are long enough to penetrate the furring strip and secure into the block. This stability will help ensure your finishing materials stay securely attached, preventing damage or warping over time. Happy building!

AD
AD