how to adjust a shimano acera rear derailleur

How to Adjust Shimano Acera Rear Derailleur

By William Rodriguez
AD

ajusting a Shimano Acera rear derailleur can significantly improve your bike's shifting performance. Whether you've recently installed it or it's become misaligned over time, with the right tools and some patience, you can restore smooth shifting.

Before you start, ensure you have a Phillips #2 screwdriver and a crank arm removal tool. This guide assumes a basic understanding of bike maintenance. If you're unsure about any steps, consider seeking professional help.

Understanding Your Derailleur

The rear derailleur is responsible for shifting the chain between the cogs on your bicycle's rear wheel. It consists of a mirror-like cage that houses the pulleys and a parallel linkage that moves the cage. Understanding these components will help you identify and correct any issues.

AD
an image of a bicycle with the words art's cyclery written below it
an image of a bicycle with the words art's cyclery written below it
How to Adjust your Shimano Rear Derailleur | #CGT - Bike School
How to Adjust your Shimano Rear Derailleur | #CGT - Bike School
How to Service Your Shimano Derailleur Clutch
How to Service Your Shimano Derailleur Clutch

Before adjusting, check the derailleur's alignment. While applying pressure on the pedals, observe the derailleur. If it wobbles or moves sideways, it's misaligned. If you're unsure, compare it with the front derailleur, which should be centered and stable.

Adjusting The Limiter Screws

The limit screws regulate the derailleur's movement, preventing it from shifting past the smallest or largest cogs. They are marked 'H' (high) and 'L' (low) on the derailleur's body. Tightening these screws limits the derailleur's range of motion, while loosening allows for more movement.

How To Adjust Shimano Front Derailleur On Mountain Bike Easily
How To Adjust Shimano Front Derailleur On Mountain Bike Easily
an instruction manual for how to install the front end of a car's engine
an instruction manual for how to install the front end of a car's engine

To adjust, shift onto the smallest cog, then turn the 'L' screw clockwise until it lightly contacts the derailleur's stop, then back it out about 1.5 turns. Next, shift onto the largest cog and repeat with the 'H' screw. Start with small adjustments (quarter or half turns) to avoid over-tightening.

Adjusting The Indexing

Indexing determines the gear that the derailleur will shift into when the lever is released. Over time, the indexing can go out of sync, resulting in improper shifts. To adjust, start with the gear shifter in the middle position.

AD

Shift through the gears several times, counting the gear number and listening for smooth, even shifts. When you find a gear that doesn't shift smoothly, turn the barrel adjuster clockwise or counterclockwise in small increments (90-degree turns) until the shift is smooth again. Repeat this process until all gears shift smoothly.

Aligning The Derailleur

Proper alignment is crucial for smooth shifting. If your derailleur isn't aligned, adjust it before fine-tuning indexing. To do this, start by shifting onto the smallest cog, then turn the barrel adjuster clockwise until the chain is just barely touching the cog. Adjust the derailleur's position by loosening the clamp bolt, nudging it to the desired position, then tightening the bolt again.

Finally, take your bike for a test ride. Pay close attention to the shifting performance. If you find that the shifting isn't as smooth as you'd like, make further adjustments as needed. Regular maintenance, including adjustments to your derailleur, will help keep your bike shifting smoothly and efficiently.

AD
AD